Interior Fuse Box Installed

Bytomas February 7, 2009January 26, 2012

I installed the vent panel and fuse box in the FJ. I must say I think I finally found the place for the auxiliary fuse box. The box will be easy to access when fuses need to be checked. The wire has plenty of space to route behind the panel.

Electrical

Roof Wire Routing
Bytomas February 8, 2009October 15, 2026

I spent a long time getting up the nerve to cut a hole in the roof of the FJ Cruiser. I wanted to be sure that when I created my wiring path it would allow multiple wires and facilitate changes. For water proof accessories I look to the marine industry. In this case I looked…

Read More Roof Wire Routing
Electrical

Rear Wiring Harness
Bytomas September 9, 2010October 15, 2026

In an effort to build our new Toyota FJ Cruiser in the cleanest way possible I am creating custom wiring harnesses for all my electrical accessories. Today’s project was building the harness for the rear of the FJ. This harness will provide the power to the accessories mounted in the rear of the FJ as…

Read More Rear Wiring Harness
Electrical

Accessory Power System Post Index
Bytomas February 1, 2009October 17, 2014

Accessory Power System Post Index Parts Accessory Switches Ready to Install At a glancePublishedFebruary 1, 2009ArchiveFJ Cruiser-era archiveTopicsElectricalIn this storyAccessory Power System Post Index Parts Accessory Switches Ready to Install

Read More Accessory Power System Post Index
Electrical

New Accessory Electrical System Parts
Bytomas January 27, 2009October 15, 2026

So I finally have all the parts to rebuild my auxiliary electrical system for the FJ Cruiser. I was using Blue Sea fuse boxes but I have found a much better box for Automotive applications. The system is being designed to run off an axillary battery system with both switched and unswitched applications. I will…

Read More New Accessory Electrical System Parts
Electrical | Electronics

USB Charge Ports Installed
Bytomas October 11, 2014October 15, 2026

“Not enough USB Charge Ports”. If you’re like me and driving a preUSB truck, setting up USB charging is a pain. With only one auxiliary 12 volt socket in the Toyota FJ Cruiser two USB sockets was the limit and for that I had to give up the aux port. I also had a tendency to go…

Read More USB Charge Ports Installed
Electrical | How Tos

Second Horn Install
Bytomas November 23, 2008October 15, 2026

Optional Horn Relocation to Front of Radiator I was starting on implementing my auxiliary power fuse/distribution block today and needed the location of the optional horn for components used for my auxiliary power system. I pulled up the electrical diagram and found that the horn wire is GR-B (Grey/Black). Using this information I was able…

Read More Second Horn Install

2 Comments

Pingback: Found the best place for Aux Electrical Fuse Box - Toyota FJ Cruiser Forum
APRS says:

July 11, 2010 at 12:57 AM

Tomas,
Could you please fix your APRS station. A generic WIDE* creates problems on the network. For a home station use an unproto of APRS,WIDE2-2. For a mobile, use APRS,WIDE1-1,WIDE2-1. This will get you on the map anywhere there is a Digi or Igate. Using that many Digi’s in your Unproto is a big no no also.
Thanks, Kevin

Reply

Similar Posts

2 Comments

Leave a Reply Cancel reply