How Tos   ·   March 2012

Rooftop Tent Mildew Cleaning

This is the method recommended by ARB. For really bad mildew it will require removing the tent from the platform.

Mildew can develop any time your tent is stored wet. It looks bad, smells bad and can damage your tent’s waterproof coatings. DON’T LET IT START.

Alas, if it already exists, here’s how to approach it:

  • Try some light scrubbing with a sponge during a regular cleaning session.
  • If mildew is still apparent, mix 1 oz. of MiraZyme® (or similar product) to 20 gallons of water in a bathtub and dip the whole tent.(Note: Lysol® also works, but its scent is attractive to bugs and critters and is thus not recommended).
  • For spot treatment, use 0.5 oz. of MiraZyme® (or similar product) per 1 gallon of water and thoroughly scrub afflicted areas by sponge.
  • Set up the tent in a shaded spot and allow it to air dry.
  • Then, mix 1 cup of salt and 1 cup of concentrated lemon juice with 1 gallon of hot water.
  • Rub the solution into the visible mildew and once again, allow the tent to dry.

This procedure will stop mildew growth and eliminate the odor, but it will never remove the stain.

Similar Posts

  • Gear Care

    Most of us have invested lots of money in our gear we use for adventure travel. This section has information on how I care for and store the gear that we use for our travels. If you have any recommendation or ideas for this section please send me an email about them. At a glancePublishedJanuary…

  • Boot Care

    Having invested lots in the boots we wear for our travels, cleaning and condition is very important to extend their life. Cleaning removes the small dirt particles that get in the pores of the leather which contribute to the breakdown of the leather. Cleaning also removes any chemicals that are on the surface of the…

  • |

    Second Horn Install

    Optional Horn Relocation to Front of Radiator I was starting on implementing my auxiliary  power fuse/distribution block today and needed the location of the optional horn for components used for my auxiliary  power system. I pulled up the electrical diagram and found that the horn wire is GR-B (Grey/Black).  Using this information I was able…

Leave a Reply

Your email address will not be published. Required fields are marked *

Captcha loading...

This site uses Akismet to reduce spam. Learn how your comment data is processed.