All Pro Off Road Rear Bumper Installed
To help complete the finished look of our Toyota FJ Cruiser I installed an All Pro Off Road rear bumper. The stock rear bumper is a simple plastic skin and is prone to damage and the silver side caps tend to get knocked off.
The All Pro Bumper uses a minimal design which keep the weight down. The lines are very clean and the rear bumper adds a finished look. Unlike the front bumper, the rear bumper in mostly cosmetic so it does not need to be built out of heavy duty steel.
The All Pro bumper provides two recovery points that are in-line with the frame.
With our 1″ body lift I needed to remove the entire center section of the original plastic bumper.
To give the bumper a clean cosmetic look I used pond rubber to fill the space between the bumper and the body. The rubber is glued to the body and the bumper with contact cement.
Cost: $700.00
Time: 2.5 hours
Looks great! Have you mounted your trailer hitch to it?
Yes, I have a fabbed hitch. I’ll get that posted later this week.
I just saw in a post you have a tire carrier on your all pro rear bumper. Where did get that I have the same bumper and have been looking for a tire carrier. Thank you I am also located in Colorado Springs Co.